Older cars such as the 1967 Chevrolet Camaro RS do not have replaceable headlight bulbs. Instead, they have sealed beam headlights. When installing new sealed beam headlights, the entire headlight unit -- glass and all -- is replaced. You can install new headlights for your 1967 Camaro RS in about 10 minutes. The installation procedure is the same on the passenger and driver side.
Tools Used: Replacement headlight, Phillips screwdriver
Headlight Installation
Remove the two Phillips screws from the inside edge of the headlight retaining bezel directly in front of the headlights. Grasp the bezel and pull it off. Now you'll see the headlight mounting ring.
Remove the Phillips screws from the headlight mounting ring, and then slide the mounting ring off with your hands.
Pull the old headlight a few inches away from the car. Be careful, it's attached to a wiring harness.
Unplug the wiring harness from the rear of the headlight.
Plug the wiring harness into the new headlight. Set the headlight in its place.
Push the headlight mounting ring around the headlight. Insert the tighten the Phillips screws.
Push the headlight bezel back into place. Insert and tighten the two Phillips screws.
0 Comments