1995 Mustang Workshop Manual
Engine Controls, Electronic
REMOVAL AND INSTALLATION
Camshaft Position (CMP) Sensor
3.8L Engine
Removal
1. Disconnect battery ground cable (14301) .
2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor).
3. Remove stator camshaft position sensor retaining screws and distributor stator (camshaft position sensor) from camshaft position sensor housing.
4. If removing camshaft position sensor housing from the engine front cover (6019) , proceed with Removal Step 5. If camshaft position sensor housing is not being removed, proceed to Installation Step 6.
5. CAUTION: Before proceeding with this procedure, set cylinder No. 1 to 26 degrees After Top Dead Center (ATDC) of the compression stroke. Then note the position of the stator (camshaft position sensor) electrical connector. The installation procedure requires that the connector be located in the same position. Download File PDF
0 Comments