1995 Jeep Grand Cherokee Limited
REMOVAL & INSTALLATION
CRUISE CONTROL SERVO
Removal
Remove cruise control cable mounting bracket from servo. Remove servo mounting bracket. Disconnect wiring harness connector and vacuum hose from servo. Pull cable away from servo to expose retaining clip. Remove retaining clip and cable. Remove servo.
Installation
With throttle in full open position, align hole in cruise control cable sleeve with hole in servo pin. Install retaining clip. To complete installation, reverse removal procedure.
CRUISE CONTROL SWITCH
Removal & Installation (Cherokee)
1. Disconnect negative battery cable. Remove horn button by turning while pushing. Remove horn bushing, receiver and flexplate. Turn ignition switch to LOCK position and remove steering wheel nut with washer. Scribe alignment mark on steering wheel and steering shaft.
2. Remove vibration damper from steering column hub (if equipped). Remove steering wheel. Using appropriate compressor, remove lock plate snap ring and lock plate. Remove canceling cam and upper bearing preload spring. Remove horn button components from canceling cam.
3. Remove hazard warning switch knob. Remove actuator arm attaching screw. Remove turn signal switch attaching screws. Unplug cruise control switch connector. Pull cruise control harness out of column. Turn ignition switch to ON position. Remove key warning buzzer switch and retainer. Download File PDF
0 Comments