1998 Windstar Workshop Manual
Glass, Frames and Mechanisms
REMOVAL AND INSTALLATION
Door Glass and Regulator, Power Windows
Removal
1. Remove front door trim panel (23942) and front door inside panel sound insulator (20394) . Refer to Section 01-05.
2. Remove inside door belt weatherstrip.
3. Remove front door window glass (21410) as described.
4. Remove two nut and washer assemblies attaching the window regulator equalizer arm bracket (23230) .
5. Remove four rivets for RH side (six for LH side) retaining the front door window regulator base plate to door inner panel.
6. Remove front door window regulator (23200) and front door window channel bracket (23288) from vehicle.
7. Working on a bench, carefully bend tab flat to remove front door window regulator arm slides from front door window channel bracket.
8. NOTE: Use care not to break tab; if tab is cracked or broken, replace front door window channel bracket . Make sure rubber bumper is installed properly on new front door window channel bracket , if replacement is made.
Install new front door window regulator arm plastic guides into front door window channel bracket and bend tab back to 90 degrees. Download File PDF
0 Comments