2000-2003 Sentra (B15) Electronic Control Module (ECM) Case Holder Foam

July 30, 2021

ELECTRONIC CONTROL MODULE (ECM) CASE HOLDER FOAM

CAMPAIGN I.D. # / NHTSA #: P3163 / 03V-477

APPLIED VEHICLES: 2000-2003 Sentra (B15)

APPLIED VINs: 3N1CB51**1L391002 - 525647, 3N1DB51**1L020201 - 020705, 3N1AB51**2L700019 - 730181, 3N1CB51**2L550003 - 693996, 3N1AB51**3L716572 - 736783, 3N1CB51**YL003216 - 385976, 3N1DB51**YL000201 - 020126,

SERVICE PROCEDURE

Remove/discard the Foam from the inside of the ECM Case Holder as follows. The ECM Case Holder will have to be re-positioned (moved) to do this procedure.

NOTE:

• Use suitable covers to protect vehicle paint, trim, etc. when doing this procedure.

• Step one (below) only applies to vehicles equipped with a Strut Tower Cross Bar.

• Doing step one will allow clearance for removing the ECM Case Holder from the engine room wall.

1. If equipped, re-position the Strut Tower Cross Bar and remove the Strut Tower Cross Bar Mounting Bracket as follows:

a. Remove the nut/bolt that holds the Strut Tower Cross Bar to the Strut Tower Cross Bar Mounting Bracket (see Figure 1).