2000 Jeep Truck Grand Cherokee 2WD V8-4.7L VIN N
Housing Assembly HVAC: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel from the vehicle. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair, Instrument Panel Service Procedures, Instrument Panel Assembly Replacement, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Service Procedures/Instrument Panel Assembly Replacement
3. Recover the refrigerant from the refrigerant system. See: Refrigerant/Service and Repair
4. Disconnect the liquid line refrigerant line from the evaporator inlet tube See: Hose/Line HVAC/Service and Repair. Install plugs in, or tape over all of the opened refrigerant line fittings.
5. Disconnect the suction line refrigerant line from the evaporator outlet tube See: Hose/Line HVAC/Service and Repair. Install plugs in, or tape over all of the opened refrigerant line fittings.
6. Disconnect the heater hoses from the heater core tubes. Clamp off the heater hoses to prevent loss of coolant. Install plugs in, or tape over the opened heater core tubes.
7. If the vehicle is equipped with the manual temperature control system, unplug the heater-A/C system vacuum supply line connector from the tee fitting near the heater core tubes.
8. Remove the coolant reserve/overflow bottle from the passenger side inner fender shield.
9. Remove the Powertrain Control Module (PCM) from the passenger side dash panel in the engine compartment and set it aside. Do not unplug the PCM wire harness connectors. Download File PDF
0 Comments