2001 Mazda Millenia S
TILT SWITCH
Removal & Installation
1. Remove combination switch. Remove in order indicated in illustration. See Fig. 17 .
2. Reverse order to install.
Tilt Switch Removal Note
1. Remove screws. Release tabs of tilt switch from turn lever boot.
2. Slide tilt switch in direction indicated by arrow, then remove it along turn lever. See Fig. 18 .
Tilt Switch Installation Note
After installing tilt switch, route harnesses of combination switch as shown in illustration. See Fig. 19 .
Band Clip Installation Note
1. Set harness length from shaft contact portion as shown in illustration. See Fig. 20 .
2. Install band clip as shown in illustration. See Fig. 21 . Download File PDF
0 Comments