2004 Jeep Grand Cherokee Limited
DIAGNOSIS AND TESTING - VACUUM RESERVOIR
1. Disconnect vacuum hose at speed control servo and install a vacuum gauge into the disconnected hose.
2. Start engine and observe gauge at idle. Vacuum gauge should read at least ten inches of mercury.....
REMOVAL
The vacuum reservoir is located in the right/front corner of the vehicle behind the front bumper fascia (Fig. 8 ).
1. Remove front bumper and grill assembly.
2. Remove 1 support bolt near front of reservoir (Fig. 8 ).
3. Remove 2 reservoir mounting bolts.
4. Remove reservoir from vehicle to gain access to vacuum hose (Fig. 9 ). Disconnect vacuum hose from reservoir fitting at rear of reservoir.
INSTALLATION
The vacuum reservoir is located in the right/front corner of the vehicle behind the front bumper fascia (Fig. 8 ).
1. Connect vacuum hose to reservoir.
2. Install reservoir and tighten 2 bolts to 3 N.m (25 in. lbs.) torque.
3. Install front bumper and grill assembly. Download File PDF
0 Comments