1994 Continental Workshop Manual
Electronic Instrument Cluster (EIC)
Removal and Installation
1. Disconnect battery ground cable.
2. Position vehicle on a flat surface to prevent movement when shift control selector lever is out of position.
3. Turn ignition switch to unlock shift control selector lever and move lever down from front of EIC.
4. Tilt steering column down as far as possible.
5. Remove RH and LH instrument panel moulding (046A63) by pulling upward to unsnap two clips. Disconnect electrical connectors. Set instrument panel mouldings aside.
6. Remove five Torx® screws below instrument cluster that retain instrument panel finish panel (044D70) applique.
7. Unsnap instrument panel finish panel applique along top and pull instrument panel finish panel applique away from instrument panel (04320).
8. Disconnect switch assembly electrical connectors. Set instrument panel finish panel applique aside.
9. Remove three screws from bottom of instrument panel steering column cover (04459) (two screws on RH side, one screw on LH side).
10. Lift up top section of instrument panel steering column cover to undo a clip located on LH side near steering wheel (3600) . Separate upper section of steering wheel from side section near ignition switch . Slip upper section off shift control selector lever and housing (7210). ... Download File PDF
 Removal and Installation){kind=link}
0 Comments